Teflon high temperature drying mesh belt is widely used. Suzhou Tuoyang New Material Technology Co., Ltd. said that dryer mesh belt, sterilizer mesh belt, annealing furnace mesh belt, fryer mesh belt, sintering furnace mesh belt, instant noodle steamer mesh belt, etc. are all common application fields of Teflon mesh belt. All production should have a regular system. Today, Suzhou Tuoyang New Material Technology Co., Ltd. will talk about it Teflon mesh belt Safety regulations to be observed during use.
1. Teflon high-temperature drying grid belt can be put into the oven after all preparations are ready. The red indicator light indicates that the box has been heated. When the temperature reaches the controlled temperature, the red light turns off and the green light turns on to start constant temperature. In order to prevent temperature control failure, it is also necessary to take care of it. Teflon conveyor belt
2. When placing the test object, the arrangement shall not be too close. The test object shall not be placed on the radiator to avoid affecting the upward flow of hot gas. It is forbidden to bake inflammable, explosive, volatile and corrosive articles.
3. Teflon high-temperature drying grid belt When it is necessary to observe the sample situation in the studio, open the outer trunk door and observe through the glass door. However, it is better to open the door as few as possible to avoid affecting the constant temperature. Especially when working above 200 ℃, opening the box door may cause the glass door to burst due to sudden cooling. Teflon conveyor belt
4. For the oven with air blast, the blower must be turned on during the heating and constant temperature process, otherwise the uniformity of the working chamber temperature will be affected and the heating elements will be damaged.
5. It shall be placed indoors in a dry and horizontal place to prevent vibration and corrosion.
6. Attention shall be paid to safe power consumption. Power knife switch with sufficient capacity shall be installed according to the power consumption device of the oven. Sufficient power conductors and good grounding wires shall be selected.
7. The oven with Teflon high-temperature drying grid and mercury thermometer type temperature controller with electric contact shall connect two wires of the electric contact thermometer to two terminals on the top of the oven. Another ordinary mercury thermometer is inserted into the exhaust valve. The thermometer in the exhaust valve is used to check the mercury thermometer with electric contact and the hole for opening the exhaust valve for observing the actual temperature in the box. Adjust the electric contact mercury thermometer to the required temperature, and then tighten the screw on the steel cap to achieve the purpose of constant temperature, but pay attention not to screw the indicating iron out of the scale when adjusting. Resistance High temperature conveyor belt
8. When using, the temperature should not exceed the higher operating temperature of the oven.
9. In order to prevent scalding, special tools shall be used when taking and releasing the test sample.
10. After the Teflon high-temperature drying grid belt is completed, the power supply should be cut off in time to ensure safety.
